ELECTRONIC TRANSFORMER FOR HALOGEN LAMPS 12V 60W DIMMABLE

Description

• This ET-A 60/220-240 built-in electronic transformer is exclusively designed.
• Direct replacement of built-in magnetic transformers in the simple.
• Halogen lamp fittings for indoor applications (e.g. halogen lamp kits, hanging lamps, ceiling lamps and etc).
• A non-reversible fail-safe mode circuit has been specially integrated to ensure safety in case of any operational fault.
• Important information for the installation As the unit is powered by mains voltage
• During installation, power to the electronic transformer and the fixture must be disconnected at all times.
• Connect the lamps to the electronic transformer according to the schematic drawing as shown below.
• The mains cable and the lamp supply cables must not cross each other
• The mounting place must be sufficiently ventilated, with the surrounding.
• the area was maintained clear of any objects (e.g. air conditioning ducts or insulation).
• If the transformer is used for purposes other than originally intended or connected incorrectly, no liability can be taken over for possible damages
• The transformers are designed to run one or Three bulbs at a maximum total of 60W
• The total lamp wattage must be within the values indicated by transformer Fa (20-60W).
• A minimum lamp load of 35W is required for the smooth effect of leading-edge phase control dimming

Check out our Amazon. ae Store:

https://www.amazon.ae/s?me=A212XSTVVG232M&marketplaceID=A2VIGQ35RCS4UG